Now that the injectors are installed and FIC software/firmware updated, it's probably a good time to adjust the fuel map for the new injectors.
You could go ahead and start it now and calibrate the FIC, but just to make sure your car doesn't run super rich with the new injectors, might as well balance the fuel now.
To tune for fuel only, the fuel map will be the only thing needed.
The AEM FIC tuning software is pretty nifty, you can easily adjust the entire fuel map calibration (tune) with a change to injector sizes by simply right clicking any cell in the Fuel Map (MAP Load), then click 'Injector size change'. Enter the new injector capacity and the old injector capacity and bam! The map is updated.
 |
| Right click any cell and select 'Injector size change' |
 |
| Now just pump in your new and old injectors then click 'OK' |
 |
| BAM! Entire fuel map updated! |
That's it! There's no need to pull timing, adjust the O2 map or anything...
Okay! NOW onto FIC calibration!!
No comments:
Post a Comment